Van Neistat's Custom Shelf, Part 2
Published August 22, 2024 · 59s · 173,594 views
About This Video
Fifty-nine seconds. Part 2 of the custom shelf build: pre-drill your holes like a ninja, mount your corner braces, screw in 1.5-inch sheet metal screws, check level. The Spirited Man approach to domestic infrastructure in under a minute. Build it yourself, build it to last, build it to fit the specific life you are living rather than a catalog's approximation. That is the whole idea.
Transcript
like a ninja pre-drill your holes exactly in the center Mount your corner brace mark one corner brace hole screw
one of your 1 and 1/2 in sheet metal screws into the exact center you have about a 1 and 15 chance of
unintentionally hitting a stud bore a hole for your anchor with the 5/16 in masonry bit below the drywall dust out
of the hole mush the triple grip anchors you can lightly tap it with a hammer screw the corresponding Corner brace
into the Wall anchor level the Shelf Mark the opposite side corner brace hole either screw into a stud or drill a hole
for your triple grip anchor screw the corner brace in with a 1 and 1/2 in pan head sheet metal screw now Mark the
remaining two Corner brace holes remove the Shelf drill the bottom holes and install anchors install the Shelf making sure it's level and you're done
Products & Tools Mentioned
- corner braces uses
- sheet metal screws uses
- masonry bit uses
- triple grip anchors uses